DIY Emergency LED Light & Bluetooth Amplifier – Two Useful Gadgets in One Project
This project combines two practical DIY electronics ideas: an emergency LED light and a compact Bluetooth amplifier. Both are easy to make, low-cost, and extremely useful during power cuts or for portable audio.
Materials Needed
-
High-power LED (3W or 5W)
-
LED driver resistor (if needed)
-
Bluetooth amplifier module
-
Small speaker
-
18650 battery or power bank
-
Switch (ON/OFF)
-
Cardboard or plastic box
-
Hot glue gun
-
Soldering iron & wires
How to Make the Emergency LED Light
-
Mount the LED
Fix the LED on the front panel of the box. -
Connect the LED Circuit
Add resistor if required and connect to the battery. -
Add Switch
Install a switch to control the LED. -
Test
When ON, the LED gives bright emergency light.
How to Make the Bluetooth Amplifier
-
Install the Speaker
Place the small speaker inside the box. -
Connect Bluetooth Module
Connect speaker wires and power supply. -
Add Control Switch
Use a separate switch or shared power. -
Test Audio
Pair your phone and play music.
Combine Both
Place both circuits inside one sturdy box.
You can use separate switches or a single power switch depending on design.
Why This Project Is Useful
-
Works as emergency light
-
Gives portable Bluetooth sound
-
Great learning project
-
Useful during load-shedding
-
Low cost and easy to build
|


Comments
Post a Comment