DIY All component Tester Prob




Testing electronic components is a crucial step in electronics troubleshooting and repair. Here's a list of 20 common electronic components along with DIY testing methods for each:

1. Resistor:

  • Use a multimeter in resistance (ohms) mode to measure the resistance value.

2. Capacitor:

  • Use a capacitance meter or a multimeter with a capacitance setting to measure capacitance.

3. Inductor:

  • Check for continuity using a multimeter. The inductor should have low resistance.

4. Diode:

  • Use a multimeter in diode mode to check forward and reverse bias. A good diode should allow current in one direction only.

5. LED (Light-Emitting Diode):

  • Test with a multimeter in diode mode. An LED should light up when forward biased.

6. Transistor:

  • Test using a multimeter's diode mode for bipolar transistors (NPN/PNP). Check for continuity and proper voltage drops.

7. Zener Diode:

  • Test in the reverse bias direction using a multimeter. A Zener diode should exhibit a stable voltage drop.

8. Schottky Diode:

  • Test similar to regular diodes. Schottky diodes have lower forward voltage drops.

9. Photocell (LDR - Light Dependent Resistor):

  • Measure resistance in both dark and light conditions using a multimeter.

Comments

Popular Posts

F450 Drone Kit DIY Quadcopter Flying Multicopter Heli Flame Wheel Kit in Pakistan

Heat Gun – For loosening glue/seals

PVC Pipe Mini Washing Machine

DIY Mini iPhone 17 Pro Max with Paper and Cardboard

Mini Wind Turbine with PVC Pipes

Touch Sensor

PVC Pipe Mini Lathe Machine

Gas Leakage Sensor

DIY electric fireplace decor